[i2c] [PATCH] i2c: Renesas Highlander FPGA SMBus support, v2.

Andrew Morton akpm at linux-foundation.org
Wed Aug 6 05:41:42 CEST 2008


On Wed, 6 Aug 2008 11:42:33 +0900 Paul Mundt <lethal at linux-sh.org> wrote:

> On Tue, Aug 05, 2008 at 02:37:51PM -0700, Andrew Morton wrote:
> > On Thu, 31 Jul 2008 19:43:54 +0900
> > Paul Mundt <lethal at linux-sh.org> wrote:
> > > +	/*
> > > +	 * The R0P7780LC0011RL FPGA needs a significant delay between
> > > +	 * data read cycles, otherwise the transciever gets confused and
> > > +	 * garbage is returned when the read is subsequently aborted.
> > > +	 *
> > > +	 * It is not sufficient to wait for BBSY.
> > > +	 *
> > > +	 * While this generally only applies to the older SH7780-based
> > > +	 * Highlanders, the same issue can be observed on SH7785 ones,
> > > +	 * albeit less frequently. SH7780-based Highlanders may need
> > > +	 * this to be as high as 1000 ms.
> > > +	 */
> > > +	if (iic_read_delay && time_before(jiffies, dev->last_read_time +
> > > +				 msecs_to_jiffies(iic_read_delay)))
> > > +		msleep_interruptible(jiffies_to_msecs((dev->last_read_time +
> > > +				msecs_to_jiffies(iic_read_delay)) - jiffies));
> > 
> > If this task has signal_pending(), msleep_interruptible() will
> > immediately return.
> > 
> > > +	cnt = (dev->buf_len + 1) >> 1;
> > > +	for (i = 0; i < cnt; i++) {
> > > +		data[i] = ioread16(dev->base + SMTRDR + (i * sizeof(u16)));
> > > +		dev_dbg(dev->dev, "read data[%x] 0x%04x\n", i, data[i]);
> > > +	}
> > > +
> > > +	smbus_read_data(data, dev->buf, dev->buf_len);
> > > +
> > > +	dev->last_read_time = jiffies;
> > 
> > In which case I assume that the above will screw up.
> > 
> Ah, right. Yes, that should be switched to msleep instead. Feel free to
> drop the _interruptible part from the patch, or I can send an update if
> you prefer.

I did that.

highlander_i2c_wait_xfer_done() might have the same problem?



More information about the i2c mailing list