New Chipset ?
Mark D. Studebaker
mds at paradyne.com
Sun Dec 9 17:37:45 CET 2001
get the hex PCI ID with 'lspci -n'.
Add it to the supported array at the top of i2c-i801.c.
Compile and load the module.
Check dmesg for clues of success or failure.
Then try prog/detect/i2cdetect to look for devices,
and prog/dump/i2cdump to look at registers of those devices.
If all looks good, run sensors-detect.
Let us know how it works.
Norbert Zawodsky wrote:
> Hello there,
> i just played around with the 'sensors' package coming with my SuSE 7.3
> distro but I can't get it to
> do something.
> sensors-detect tries to load i2c-i801.o module, but in the system log I
> Dec 9 15:47:27 rincewind kernel: i2c-i801.o version 2.6.0 (20010612)
> Dec 9 15:47:27 rincewind kernel: i2c-i801.o: Error: Can't detect I801,
> function 3!
> Dec 9 15:47:27 rincewind kernel: i2c-i801.o: I801 not detected, module
> not inserted.
> This is part of lspci output (the important one I think):
> 00:1f.3 SMBus: Intel Corporation 82820 820 (Camino 2) Chipset SMBus (rev
> Subsystem: Asustek Computer, Inc.: Unknown device 8043
> Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop-
> ParErr- Stepping- SERR- FastB2B-
> Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
> <TAbort- <MAbort- >SERR- <PERR-
> Interrupt: pin B routed to IRQ 10
> Region 4: I/O ports at e800 [size=16]
> The motherboard is a brand new ASUS P4T with a Pentium iV CPU
> Can I force the i801 driver or do I have to wait for a '820' driver?
> Greetings from a sunny but cold (-7.8) Vienna
More information about the lm-sensors