[PATCH 2.6] i2c-parport: support the ADM1031 evaluation board

Greg KH greg at kroah.com
Fri May 28 22:46:29 CEST 2004

On Sat, May 22, 2004 at 10:53:24PM +0200, Jean Delvare wrote:
> Hi Greg,
> The following patch adds support for the ADM1030 and ADM1031 evaluation
> boards to the i2c-parport and i2c-parport-light drivers. They are almost
> compatible with the already supported ADM1025 and ADM1032 boards, except
> that the ADM1032 board needs some pins to be set high to draw its power,
> while the same pins power up heating resistors on the ADM1031 board. I
> considered it was a bit dangerous to do that by default, so I ended up
> with two different device definitions, one with powering pins set, and
> one with these pins cleared.
> Please apply,

Applied, thanks.

greg k-h

More information about the lm-sensors mailing list