[lm-sensors] About the "CPU temp" output of ADM1025A chip

[Yongkui Han]

Hi Rudolf,

Thank you very much!

You are very nice, and you really helped a lot.

Yongkui


On 11/5/06, Rudolf Marek <r.marek at assembler.cz> wrote:
>
> > I run the CPU burn benchmark for only 1 minute (plus 15 minutes system
> > idle before running cpuburn, and 15 minutes system idle after cpuburn
> > stops running), I even got the following message when the cpuburn
> > program started running for less than 1 minute:
> > ---------------------------------------------
> > Message from syslogd at localhost <mailto:syslogd at localhost> at Mon Oct 30
> > 11:39:21 2006 ...
> > localhost kernel: CPU0: Temperature above threshold
>
> I think it is 90C so now you know that the temp is measured correctly. If
> you
> have 88C this may be just error of measurement. So your cooling cools
> quite well.
>
> > Any suggestions on controlling the CPU fan speed?
>
> Please check the other thread.
>
> Regards
> Rudolf
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.lm-sensors.org/pipermail/lm-sensors/attachments/20061106/9c5bfaa1/attachment.html