[lm-sensors] F8000 support added to f71882fg driver, test please.

Chuan-kai Lin cklin at cs.pdx.edu
Mon Dec 15 23:31:18 CET 2008


On Mon, Dec 15, 2008 at 11:16:02PM +0100, Hans de Goede wrote:
>>  3. The full-speed number seems to record the maximum measured fan
>>     speed instead of the maximum possible fan speed.
> So this gets updated by hardware? This is not mentioned anywhere in
> the dcos, but if that is the case that would be good!

Appears to be the case.  See previous message attachment: in loaded.txt
the _full_speed values are higher than in idle.txt.

>>  4. I cannot change fan speed by altering tempX_auto_pointY_pwm
>>     values.  However, both the CPU fan and the case fan do speed up
>>     when the system gets warm.
> what does cat pwmX_enable give you, if it gives 3, the relevant pwm is
> in thermostat mode see the documentation I also attached.

See previous message attachment: they both report 2.

-- 
Chuan-kai Lin
http://web.cecs.pdx.edu/~cklin/




More information about the lm-sensors mailing list