[lm-sensors] "No sensors found!" on Intel Entry Storage System SS4200
khali at linux-fr.org
Fri Jan 29 14:46:03 CET 2010
On Wed, 2 Sep 2009 21:29:16 +0200, Jean Delvare wrote:
> On Wed, 2 Sep 2009 02:23:52 +0200, Hubert Kario wrote:
> > On Tuesday 01 September 2009 23:27:28 Tech2009 wrote:
> > > Thank you for the suggestions.
> > >
> > > I looked in sysfs on the factory distro, no sign of dme1737 there (see
> > > attached). However there are other i2c devices not on my debian
> > > install...you could be right about the direct port io, but without
> > > disassembling the library it's hard to tell.
> > >
> > > I tried loading dme1737 with force_start, but that made no difference
> > > for me.
> > I was thinking about using the 'force' parameter to givie the address
> > explicitly to the module, the device may be on non standard port.
> > sensors-detect is usually more capable of detecting devices than kernel
> > modules
> Good point. The dme1737 driver only recognizes version/stepping value
> of 0x69 as the SCH5027. sensors-detect OTOH recognizes all version/
> steppings from 0x69 to 0x6f. It would be interesting to see a dump of
> the chip (modprobe i2c-dev then run i2cdump), I'd guess you have a
> version/stepping value > 0x69.
Ping. Can we have the output of i2cdump for your chip, please?
> It might help to have a physical look at the chip and read the top
> marking, if this is possible.
This would also be helpful, if possible.
More information about the lm-sensors